Duplo DF-1000, Instruction Manual

Page: 71 / 86

4-21
4. ERROR MESSAGES
4-3. Key Input Error Messages
When setting non-standard paper length, folding stopper position during custom folding,
and folding misalignment adjustment values, entering a value exceeding the scope of
specifications displays the following error messages on the LCD.
“TOO SHORT”
“TOO LONG”
“OUT OF CORRECT”
<Solution>
Enter a value within the scope of specifications.
For details, refer to “1. STANDARD FOLDING OF NON-STANDARD PAPER” ( p.3-2) , “2.
CUSTOM FOLDING” ( p.3-5) in Chapter 3 APPLIED USE , and “1-2. Correcting Folding
Misalignment Along Vertical Length of Paper” ( p.4-5) in this Chapter .
4-4. Motor and Sensor Error Messages
When motors and sensors in the unit malfunction, the following error messages will be
displayed on the LCD.
(1) Main motor malfunction
“MOTOR ERROR 1”
“MOTOR 1 OVERLOAD”
<Cause>
Troubles such as main motor’s locking have occurred due to paper jamming.
<Solution>
First, turn OFF the power.
For details on removing jammed paper, refer to “3. WHEN PAPER JAMMING OCCURS”
( p.4-15) .
If after turning OFF the power and implementing the following solution, and then turning
ON the power again, the same message appears again, contact your nearest dealer. Wait
for more than 30 seconds first before turning ON the power again.