4-6
1. CORRECTING FOLDING MISALIGNMENT
Length A of the folded plane is the length from the trail edge of the paper to the center of
paper slack.
Length B of the folded plane is the length from the center of paper slack to the folding stopper.
Therefore by changing the position of the folding stopper, length B of the folded plane can be
adjusted.
Folded plane
length A
Folded plane length B
Folded plane length A
Folded plane
length B
(2) Correcting single fold
Adjust the length of single folded plane using the “+” or “–” key of the folding plate 1 folding
stopper adjusting key.
+3.0 mm
+3.0 mm
direction
A4 +3.0/ ...
STAND BY
Ejection direction
In this example, by increasing the folded plane length B by 3 mm, A will become 3 mm
shorter, and as a result, folding misalignment of 6 mm in total can be improved.
To increase B, press the “+” key and move the folding stopper in the direction
shown
below
. To increase B by 3 mm, press the “+” key until “+3.0/ ...” appears on the LCD.
<Example 1>
When folded plane length B is 6 mm
shorter than folded plane length A
–3.0 mm
6 mm
Folding plate 1 folding
stopper adjusting key
Summary of Contents for DF-1000
