32
* When the microcomputer is currently placed in ID authentication mode, this setting is required
even if you want to set the serial programming operation mode to command protection mode,
4.2.6. Set Up the Serial Programming ID for Setting
(Not required this setting when you do not use serial programming ID.)
This is serial programming ID for setting to place microcomputer in ID authentication mode.
Address
：
Fixed to #00000020
Size
：
Fixed to 16
Data
：
ID for setting
* This ID is applied for the ID for OCD, test, and self-programming.
* When microcomputer has been placed in ID authentication mode, and you want to use the
same ID, set the same value as authentication ID.
4.2.7. Set Up Option Byte
(Not required this setting when you do not use option byte.)
The following is the setting value to set option byte.
Address
：
Fixed to #00000040
Size
：
4~32
Data
：
Option byte setting value
* Above is set when you enable option byte setting with FUNC-D4.
* For the setting value of option byte, please refer the hardware manual for the microcomputer.
* Set option byte in little-endian format in a unit of option byte register (32 bit). When there is
more than one register and those addresses are apart from each other, describe the
sequential address data from the start option byte register. For undefined address data, use
FFFFFFFFh. Make sure to describe whole option byte registers in one line.
