22
With the System disarmed, mount the components in their desired locations. Note that
when each enrolled component is removed from its backplate, the Sounder will beep to
indicate that the component’s tamper switch has been activated.
7 A: Controller
Select a dry location close to an unswitched AC source and a telephone connection.
Locate the Controller backplate on the wall and mark all desired screw locations; refer to
Figure 1. It is suggested that wall anchors be used for all screw locations. When the
anchors have been placed, secure the backplate to the wall. Avoid mounting the
Controller behind mirrors, near metal walls, metallized wallpaper, metal stands and
cabinets, etc. Secure the Controller to its backplate, and secure the adaptor power cord
to the cord stress relief clip on the Controller.
Chapter 7: Mounting the Components
Figure 2. Sounder Backplate
SCREW LOCATION
ENSURE PROPER
ORIENTATION OF
BACKPLATE.
Figure 1. Controller and Keypad Backplate
ENSURE PROPER
ORIENTATION OF
BACKPLATE. FLAT
PART OF KEYS TO
FACE TOWARDS
FLOOR.
SCREW LOCATION
Chapter 7: Mounting the Components
7 B: Sounder
The Sounder should be located so that it will be heard throughout the premises when it is
activated. If the security System features smoke and fire detection equipment, the Sounder
should be located outside of the sleeping areas.
Locate the Sounder backplate on the wall and mark all desired screw locations; refer to
Figure 2. It is suggested that wall anchors be used for all screw locations. When the
anchors have been placed, secure the backplate to the wall. Secure the Sounder to its
backplate, and secure the adaptor power cord to the cord stress relief clip on the
Sounder.