DRUCK
TEMPERATUR
&
Leitenberger GmbH •
Bahnhofstr. 33 • D-72138 Kirchentellinsfurt •
Tel. +49 (0) 7121-90920-0 • Fax +49 (0) 7121-90920-99 •
• www.druck-temperatur.de
GERMANY
DT
www.
-Cal.net
LR
MANUAL
LPC 300 Druckkalibrator
300 Pressure Calibrator
LPC
76
The calibrator and the reference pressure sensor are connected to each other electrically using
the connecng cable, which is mounted straight to the calibrator. When exchanging the sensor,
use the 8-pin plug connector at the sensor.
In order to make the electrical connecon for a
reference pressure sensor (in line with the
orientaon guide) and secure it using the connecon sleeve (screw in the connecon sleeve
clockwise without too much force). To loosen the connecon, the connecon sleeve must be
turned an-clockwise. To disconnect the sensor, do not pull on the cable, but rather only on the
connector body.
LPC-S
b) Electrical connecon using the extension cable (order-code
)
LPC KABEL
-
(standard for pressure ranges above 1000 bar, oponal for lower pressure ranges)
CAUTION!
Only ever use the original extension cable order-code
for the remote
LPC KABEL
-
operaon of
reference pressure sensors, and never more than a single
LPC-S
extension cable.
Follow the instrucon as described above (“a)“). In addion, the other end of the extension cable
must be connected to the coupling of the calibrator. Bring together the corresponding cable plug
connector in line with the orientaon guide and secure it using the connecon sleeve (srew in the
connecon sleeve clockwise without too much furce). To loosen the connecon, the connecon
sleeve must be turned an-clockwise. To disconnect, do not pull on the cable, but rather only on
the connector body.