SECTION 4
OPERATING
Page 20
TD-15H
DRESSTA
STARTING THE ENGINE
•
Follow the correct method for starting the engine.
•
Before any attempt to start the engine, check the ether container or insure that a supply
of starting fluid is available under pressure and the system is in working condition.
Pressing the switch in the instrument panel makes ether injection.
IMPORTANT: The ether injector is to be used only for starting. Misuse of the ether injector while
the engine is running can result in serious damage to engine.
1. Perform all activities as described in item 1-6. Refer to NORMAL START (temperature above
0 [°C]).
2. Press the start button and during cranking press the ether injector switch. Allow one to two
seconds for the chamber in the valve to fill then, with the engine cranking, release the ether
injector switch to release a measured shot of starting fluid into the engine. If temperature is
below –18 [°C], additional ether may be required. If the engine does not fire with a maximum of
2-3 injections, determine the cause and correct before again attempting a start.
IMPORTANT: Crank the engine for 30 seconds at a time no more. If it does not start, allow the
cranking motor to cool two or three minutes before cranking again.
4.6.3. ENGINE START AFTER OIL CHANGE OR PROLONGED STANDSTILL
(over 5 days) (FIG.4.15).
1. Perform all activities as described in item 1 to 3 and 5 to 6. Refer to NORMAL START.
2. Place the engine speed control lever in OFF position (Fig. 4.16).
3. Press engine start switch (6) on the instrument panel. Crank the engine until oil gauge (4)
registers oil pressure or the low oil pressure warning light goes off. Depress the start switch.
4. Move the engine speed control lever to idle position (Fig.4.16).
5. Perform all activities as described in item 7 to 9. Refer to NORMAL START.
4.7. STOPPING THE ENGINE (Fig. 4.17)
Fig. 4.17. Stopping the Engine
1. Brake Lock Knob
2. Engine Coolant Temperature Gauge
3. Ripper Control Lever
4. Blade Control Lever
5. Brake and Decelerator Pedal
6. Electric System Master Switch
7. Transmission Shift Lever
8. Engine Speed and Shut Down Lever
9. Transmission Neutral Lock Lever
https://www.truck-manuals.net/
Summary of Contents for 32501
