Draytek VigorIPPBX 2820 Series, User Manual

Page: 234 / 379

VigorIPPBX 2820 Series User’s Guide 224
This page displays the QoS settings result of the WAN interface. Click the Setup link to
access into next page for the general setup of WAN interface. As to class rule, simply click
the
Edit link to access into next for configuration.
You can configure general setup for the WAN interface, edit the Class Rule, and edit the
Service Type for the Class Rule for your request.
G G e e n n e e r r a a l l S S e e t t u u p p f f o o r r W W A A N N I I n n t t e e r r f f a a c c e e
When you click Setup , you can configure the bandwidth ratio for QoS of the WAN interface.
There are four queues allowed for QoS control. The first three (Class 1 to Class 3) class rules
can be adjusted for your necessity. Yet, the last one is reserved for the packets which are not
suitable for the user-defined class rules.
WAN 1
WAN2
Enable the QoS Control The factory default for this setting is checked.
Please also define which traffic the QoS Control settings
will apply to.
IN- apply to incoming traffic only.
OUT- apply to outgoing traffic only.
BOTH- apply to both incoming and outgoing traffic.
Check this box and click OK , then click Setup link again.