Draytek Vigor2926, User Manual

Page: 913 / 968

Vigor2926 Series User’s Guide 897
Current mode is 11bgn
% <Note> Please restart wireless after you set the channel
> wl config channel 13
Current channel is 13
% <Note> Please restart wireless after you set the channel.
> wl config preamble 1
Long preamble is enabled
% <Note> Please restart wireless after you set the parameters.
> wl config ssid 1 enable dray
SSID Enable Hide_SSID Name
1 1 0 dray
% <Note> Please restart wireless after you set the parameters.
> wl config security 1 wpa1x
%% Configured Wlan Security Setting:
% SSID1
%% Mode: wpa1x
%% Wireless card must be reset for configurations to take effect
%% (Telnet Command: wl restart)
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
w
w
l
l
s
s
e
e
t
t
This command allows users to configure basic wireless settings.
S
S
y
y
n
n
t
t
a
a
x
x
wl set [SSID] [CHAN[En]]
wl set txburst [enable]
S S y y n n t t a a x x D D e e s s c c r r i i p p t t i i o o n n
Parameter Description
SSID It means to type the SSID for the router. The maximum character
that you can use is 32.
CHAN[En] It means to specify required channel for the router.
CHAN: The range for the number is between 1 ~ 13.
En: type on to enable the function; type off to disable the function.
txburst [enable] It means to enhance the performance in data transmission about
40%* more (by enabling Tx Burst). It is active only when both sides
of Access Point and Station (in wireless client) invoke this function
at the same time.
0: disable the function.
1: enable the function.
E E x x a a m m p p l l e e
> wl set MKT 2 on
% New Wlan Setting is:
% SSID=MKT
% Chan=2
% Wl is Enable