7. Temperature measurement
35
Dr. A. Kuntze
I
Gutes Wasser mit System
Robert-Bosch-Str. 7a
40668 Meerbusch
+49 (0) 2150-7066-0 / Fax -60
www.kuntze.com
7.
Temperature measurement
All settings concerning temperature measurement and compensation
are found in the submenu IN/OUT =>TEMP. Select the symbol IN/OUT
in the main menu, and TEMP in the submenu.
Type
For Neon
®
CM you can select Pt100 or Pt1000. For Neon
®
IL NTC is
shown as sensor type – other temperature probes are not supported.
Select Pt100 if you have connected a Pt100, or Pt1000 if you have
connected a Pt1000. Other temperature sensors cannot be used.
Note
You can connect temperature sensors with 2-wire or
3-wire connection. If you use 3-wire connection,
make sure that your sensor supports this type of
connection.
Correction
If the sensor is connected with a 2-wire cable, slight deviations might occur between measured
and real temperature. Check the temperature once during installation, and calibrate the temperature
measurement if necessary by entering a correction value between -10°C and +10°C.
Note
If the mode is manual the input for the correction value is hided.
Reference
The reference temperature is the temperature to which the measurement iscompensated.
