Operating Instructions
Troubleshooting
© Copyright by Markem-Imaje CSAT GmbH
ITS6_135_Manual_EN.doc
Subject to Technical Modifications
Page 273 / 370
Code Display:
CA = Current Alarm;
S= Status
M
essage
or
A
larm?
C
ause of the message /
R
emedial action:
To be
elimin.
by
91
CA "91= Cleaning
unit: cartridge
empty!"
M
C: The cartridge with the cleaning fluid is emp-
ty.
O, T
R: Insert a new cartridge with cleaning fluid.
S:
"0= Printer waiting
for line start"
C: During the cleaning process, so much fluid
can be used up that the upper fill level sen-
sor of the intermediate reservoir will no
longer respond.
O, T
R: Wait one or two minutes until more cleaning
fluid has flowed into the intermediate reser-
voir. If the message is still shown after-
wards, then the cartridge with the cleaning
fluid is empty is empty and has to be re-
placed by a new one.
C: Sensor system out of order.
S, C
R: Check sensor the fill level 520-B1 of
the intermediate reservoir, lines and con-
tacts, have defective parts replaced (by
CSAT customer service).
92
CA "92= Collection
pan: out of posi-
tion"
A
C: The collection pan is not in its proper posi-
tion. The sensor in question is responding.
O, T
S:
"30= Printer not
ready to START"
R: At the rear of the printer push the collection
pan all of the way into the machine.
C: Sensor system out of order.
S, C
R: Check 400-B14, lines and contacts,
have defective parts replaced (by CSAT
customer service).
93
CA "93= Residual ink
intermediate res-
ervoir full!"
A
C: The residual ink bottle is so full that the re-
sidual ink can no longer run out of the inter-
mediate reservoir. The sensor in question is
responding.
O, T
S:
"30= Printer not
ready to START"
R: Insert empty residual ink bottle into the
holder and wait until the residual ink has run
out of the intermediate reservoir.
C: Sensor system out of order.
S, C
R: Check 400-B13, lines and contacts,
have defective parts replaced (by CSAT
customer service).
94
CA "94= Unwinding
unit: Pressure
roller of web ten-
sion control un-
locked"
A
C: The frame with the pressure roll is unlocked.
The printing substrate is no longer being
pressed by the pressure roller against the
rubber roller and, therefore, can slip off of it.
The sensor in question is responding.
O, T
S:
"30= Printer not
ready to START"
R: Press down the frame with the pressure
roller until the two black latches lock into
place.
C: Sensor system out of order.
S, C
R: Check 500-B45, lines and contacts,
have defective parts replaced (by CSAT
customer service).
