Complete 101 Series Installation Manual
99-25517-I001 July 2022 Rev. B
96 |
P a g e w w w . a n t h o n y i n t l . c o m
4.
When you get near the bottom of the door, carefully align the two bottom corners of the gasket onto the
bottom corners of the plastic cover, with the gasket arrow facing the door rail and cover.
5.
Continue to insert the gasket arrow into the groove around the remaining perimeter of the door surface by
pressing the gasket firmly against the plastic cover, sliding from side to side, and applying full pressure against
the gasket, forcing the gasket arrow into the groove in the plastic.
6.
Confirm that the entire gasket arrow has been completely inserted into the groove of all four plastic rail
covers.
WARNING
Note: Pay careful attention that the arrows are firmly pressed into the grooves at the
corners. A rubber mallet can be utilized if the arrows do not easily insert into the
grooves.
WARNING
Note: If the gasket has any signs of deformation from the packaging it is acceptable to
use a low heat blower to warm the gasket. This can be performed by blowing warm air
on the gaskets in a sweeping motion to warm the gaskets between 80°F and 110°F so
the gasket can reshape.
