Complete 101 Series Installation Manual
99-25517-I001 July 2022 Rev. B
59 |
P a g e w w w . a n t h o n y i n t l . c o m
Section 14 – Removing & Replacing the Hold-Open Assembly
Please read the instructions in their entirety. It should answer most of your installation questions. For personal and system safety, and
optimum product performance, make sure you thoroughly understand the contents before installing, using, or maintaining this product.
You must remove the door from the frame and place a steady flat surface to remove and replace the hold-open assembly. Once the door is
safely on a secure working surface use the following instructions to remove and replace the hold-open assembly.
PROTECTIVE GEAR NOTICE
Protective Eyewear– Potential risk of eye injuries, protective eyewear required when
performing this, and any other associated tasks.
Protective Gloves– Potential risk of injury to your hands, protective gloves required when
performing this, and any other associated tasks.
Footwear Protective – Potential risk of injury to your feet, wearing protective footwear is
required when performing this and any other associated tasks.
Removing the Hold-Open Assembly
1.
Remove screws from the hold-open standoffs, which are located on the door rail and frame. Refer to Figure 14.1.
2.
Remove the hold open, standoffs, and discard them.
3.
When replacing the hold-open arm, reverse Step 1 by inserting the screw through the mounting hole in the arm and tightening it into
the frame mounting hole using the #2 Philips head screwdriver. Refer to Figure 14.1.
Figure 14.1 Removing hold-open assembly from door.
NOTICE
Note: Parts depicted in Red can be replaced, parts in Black are not replaceable
