Complete 101 Series Installation Manual
99-25517-I001 July 2022 Rev. B
15 |
P a g e w w w . a n t h o n y i n t l . c o m
Net Opening & Frame installation
Read the instructions in this Section completely before installing the frame. Before installing the frame, confirm that the size of the net
opening accommodates the finished frame, net opening should be larger by 1/8” than the frame size, there should be a gap of 1/8" on top,
1/8" on the right side, and 1/8" on the left side. If the gap tolerances exceed 3/8”, the net opening will have to be enlarged to reduce the gap
within 1/8”. Also, ensure that there is a minimum of 3-1/2” clearance from floor to top of the bottom sill (opening).
PROTECTIVE GEAR NOTICE
Protective Eyewear– Potential risk of eye injuries, protective eyewear required when
performing this, and any other associated tasks.
Protective Gloves– Potential risk of injury to your hands, protective gloves required when
performing this, and any other associated tasks.
Footwear Protective – Potential risk of injury to your feet, wearing protective footwear is
required when performing this and any other associated tasks.
The following instructions will ensure proper frame installation:
1.
When installing the frame,
DO NOT
install the Frame directly on Sheetrock, the frame is designed to be installed on
Cooler/Refrigeration Cases/Freezer Boxes only.
2.
Ensure that the Sealing Frame Flap is fully engaged to, Sill, Header, and Jack Studs creating a seal without any gaps (see Figure 2.4).
3.
Make sure to
DO NOT
force the frame if the fit is too tight, doing so may cause you to break the Sealing Frame Flap or tweak the
Frame.
4.
Insert a mounting screw into a mounting hole in each corner of the frame and tighten each screw until it is approximately a quarter
inch from being flush.
5.
Check the frame is aligned properly or square.
6.
Use a measuring tape to measure diagonally from one corner to the opposite and note the distance.
7.
Measure the distance between the remaining two corners.
8.
Both measurements should be the same, or within a 1/16” difference.
9.
Confirm the frame and frame flanges are vertically and horizontally aligned (plumb) to the wall surface around the net opening.
10.
Place a level on the top flange of the header frame to check if it is horizontally aligned.
11.
If the top of the header frame sags or bows, correct it as necessary.
12.
When the frame is completely aligned, tighten all mounting screws securely until each is flush with the frame surface.
DO NOT
over-tighten the screws, as this can cause the frame to become out of square.
13.
Check the entire frame to ensure installation is correct. If needed see refer to the “Shimming Frame” section for instructions on
how to use shims to align the frame properly.
WARNING
Warning: DO NOT over
-tighten screws onto the frame, as this may cause bowing, sagging, or
the frame to become out of square. This will cause installation issues with Door's proper
function. Adjusted the frame as needed to ensure it is square and free of bowing and sags.
