Complete 101 Series Installation Manual
99-25517-I001 July 2022 Rev. B
112 |
P a g e w w w . a n t h o n y i n t l . c o m
Appendix H – Slimline Door Handle Replacement
The following section is only for the Slimline Handle on 101 Series Door this applies to door models 101N, 103N, and 103T.
If your door is configured with a full-length door handle the handle cannot be replaced. The following instructions will guide you on how to
replace an existing Slimline handle.
PROTECTIVE GEAR NOTICE
Protective Eyewear– Potential risk of eye injuries, protective eyewear required when
performing this, and any other associated tasks.
Protective Gloves– Potential risk of injury to your hands, protective gloves required when
performing this, and any other associated tasks.
Footwear Protective – Potential risk of injury to your feet, wearing protective footwear is
required when performing this and any other associated tasks.
1.
To remove the door handle you will need to access the screws on the back for the door rail located behind the door gasket.
Figure H.1 – Locating handle screws
2.
To locate screws, open the door enough to easily access the door gasket located on the perimeter on the inside of the door rail.
3.
Proceed by gently and carefully pulling back the door gasket portion along the area the top and bottom of the opposing side of the
handle are located, this will expose two (2) holes located on the door rail plastic, as shown in Figure H.1 as red dots.
