21
Crane 4000LE
07-2022
RL6002-003
Chapter 6
Crane 4000LE Wiring, Setup and Troubleshooting Manual
In-ground Motion Assist 360 drive and speed control
Remote control enclosure
Fig. 6.7.2 Remote enclosure ground wire connections
6.7 Install Motion Assist control unit assembly into enclosure
Fig. 6.7.1 Control unit installation in remote enclosure
Detail
“F”
Detail
“E”
Ground wire to Motion Assist 360 power supply
Ground wire to Motion Assist 360 power supply
2
10,11
10,11
7
3,4,5
TIPS AND RECOMMENDATIONS
Control unit bracket will be installed using
enclosure internal panel mounting studs.
6.7.1 Install Motion Assist 360 control unit assembly
into enclosure.
1. Remove nuts from enclosure internal panel studs.
2. Install control unit bracket onto two enclosure studs.
3. Reinstall the two enclosure nuts and tighten.
6.7.2 Connect ground wire from power supply to control
unit.
1. Connect ground wire from power supply to control
unit SHCS.
• Reference Fig. 6.7.3, Detail "D"
6.7.3 Connect ground wire from power supply to
enclosure ground stud.
1. Remove nut from enclosure ground stud and install
ground wire from Motion Assist 360 power supply to
enclosure ground stud (Fig. 6.7.4).
6.7.4 Connect ground wire from enclosure door to
enclosure ground stud.
1. Remove nut (12) from door ground stud
(Fig. 6.7.3).
2. Install ground wire ring lug on stud.
3. Reinstall enclosure ground stud nut (13), Fig. 6.7.4).
Fig. 6.7.3
Detail "E"
Fig. 6.7.4
Detail "F"
Ground wire from
door ground stud
Ground wires to power supply
13
#
Description
2
RX6002
Motion Assist 360 control unit
3
RF6018-01G
5/16 x 1/2" SHCS, SS
4
RF6019-01G
5/16" flat washer
5
RF6016-01G
External tooth lock washer
7
RC6057
Bracket
9
RX6009
Earth ground cable
10
Enclosure internal panel stud
11
Enclosure internal panel stud nut
Table 6.7.1 Control unit and hardware
9
12