67
Crane 4000LE
07-2022
RL6002-003
Chapter 19
Crane 4000LE Wiring, Setup and Troubleshooting Manual
In-ground Motion Assist 360 drive and speed control
Remote control enclosure
19.1 Install outer section container lids
45.2.1 Install outer section container lids.
WARNING
Mode switch must be in Off position.
WARNING
Press an Emergency Stop pushbutton.
TIPS AND RECOMMENDATIONS
Wings not shown to provide detail on lid
fastening.
1. Place foam rubber seal on each side of container lid
center section (Fig. 19.1.4).
• Seal has adhesive backing.
• Seals must be placed directly against center section
container lid flange as shown in Fig. 19.1.4. This will
allow proper installation of outer section container
lids and installation of flat head screws (13).
2. Install two outer section container lids using fastener
hardware in Fig. 19.1.3.
CAUTION
Insure flange gasket (
8
) is intact and holes line
up with holes in in-ground container flange.
Fig. 19.1.1
Outer section container lid
Fig. 19.1.2 Foam rubber seal
5
Fig. 19.1.3 Container lid fastener hardware
Fig. 19.1.5 Container lids installed
19 Install in-ground container covers
13
6
5
RS6033
Outer section container lid
6
RC6047
Foam rubber seal, 3/8" wide x 7/32" high
with acrylic adhesive backing
7
RC6049
Container lid center section
8
RC6046
Flange gasket
13
RF6025-01G
1/4-20 x 3/4" sealing flat head screw
Table 19.1.1
Container lid hardware
13
5
6
6
6
7
13
Fig. 19.1.4 Foam rubber seals installation
6
6
5
5
7
13
13
