8. MAINTENANCE
Before any maintenance operation, stop the machine and switch off the
electricity.
1) Grease rotary parts every 50 working hours (lubricators, piston articulated joints, gear
wheels, etc...).
2) At the end of its utilisation, wash the machine to prevent non homogeneous wasted from
solidifying; this could cause damages.
Page 12
fig. 17
As for all spare parts, address directly to
DODA dealer.
IMPORTANT!!
Switch off electricity before doing periodically
maintenance the following parts:
CHAINS
-Lift protection
I fig. 16
and grease side driving
chains
H
on both sides.
ROLLERS
- Leaving protection open, clean upper rolls
L
with water.
BRUSH
- Check that shaft
F fig. 17
rotates when the machine is in operation. If this does not happen,
act on support
G
manually: loosen bolt
H
and rotate support in the arrow sense. This rota-
tion moves forward the strainer-cleaning brush by about a millimetre every five degrees of
the graduated scale. This brush will be completely worn out when 0° indicator is reached
with respect to reference
E.
N.B.: there are two G supports, one opposite to the other, therefore they
must be adjusted perfectly on the same axis.
BRUSH REPLACEMENT
The brush is an important element to clean the strainer during machine work and washing
cycles. It is made up of a roll covered with steel wires and is subject to wear. So, can be nec-
essary to replace it once it is worn out.
H
G
E
F
Summary of Contents for SEPARATOR 2000
Page 23: ...Page 18...
