62
Vo
ice
/V
id
eo
pho
ne
Cal
ls
/P
ush
Ta
lk
You can store prefix numbers such as international call access codes or
“186”/“184” and add them to the phone number for dialing. You can store
up to seven prefix numbers.
1
m
Set./Service
Network setting
Prefix setting
Highlight <Not recorded> and press
l
(
).
If you select a stored prefix, you can check the stored contents.
To delete a stored prefix, press
i
(
) and select “Delete this” or “Delete
all” then select “YES”. If you select “Delete all”, you need to enter your Terminal
Security Code.
2
Enter a name
Enter a prefix number.
You can enter a name of up to 8 full-pitch/16 half-pitch characters.
You can enter a prefix number of up to 16 digits. The keys for entry are limited to
0
through
9
,
s
and
a
.
You can add a prefix number to the beginning of phone number when
you make a call.
1
Enter a phone number
or
call up the detailed display of a Phonebook entry, redial
item, dialed call record, or received call record.
Delete all
Enter your Terminal Security Code
YES
Information
<
Delete this
> <
Delete all>
You cannot delete the country/area code or international call access code set by
“Auto assist setting”.
<Prefix Setting>
Storing Numbers to be Added to the
Beginning of a Phone Number
Prefix Numbers
2
i
(
)
Prefix numbers
Select a name
d
or
O
o
(
)
Press
l
(
) to make a videophone call and press
p
to make a PushTalk
call.
For making a PushTalk call, adding a prefix number such as “186” or “184” to the
beginning of the phone number is disabled.
You can set whether to regard the numbers after “
:
” of a phone number
as a sub-address to access the specified phones or data terminals.
The sub-address is a number assigned to identify each ISDN terminal connected to an
ISDN line. It is also used for selecting contents on “V-live”.
1
m
Set./Service
Other settings
Sub-address setting
ON or OFF
You can set an alarm that sounds until a voice call, videophone call, or
PushTalk communication is reconnected after disconnected owing to
bad radio wave conditions.
1
m
Set./Service
Talk
Reconnect signal
Select an alarm.
<Sub-address Setting>
Making a Call Specifying a Sub-address
Information
Even if you set “Sub-address setting” to “ON”, “
:
” at the top of phone numbers and
“
:
” immediately after the prefix number or “186”/“184” are not regarded as
sub-address mark-off symbols.
+
m
-
7
-
7
<Reconnect Signal>
Setting Alarm for Reconnecting
