218
e13_nb10_7e.fm
[218/228]
Wi-Fi/Data Commun
ic
atio
n/Co
nn
ection
Wi-Fi allows you to access the Internet using wireless LAN
function. To use Wi-Fi, you need to connect to the wireless LAN
access point (Wireless LAN base unit).
Refer to the manual of your wireless LAN base unit when using the
access point at home.
Operate access point registration near the access point.
Wireless LANs (IEEE802.11 b/g) use the same frequency band (2.4
GHz) as the Bluetooth device. Therefore, using the wireless LAN device
near a Bluetooth device may cause the radio interference, lowering of
communication speed, noise, or connection fail. In this case, turn off the
Bluetooth device or keep the FOMA terminal and the wireless LAN
device at least approximately 10 m away from the Bluetooth device.
■
Enabling Wi-Fi function
<Use Wi-Fi>
1
In the main menu, [Settings]
/
[Transmission]
:
Alternatively, [Settings]
/
[Transmission]
/
[Wi-Fi settings].
2
[Use Wi-Fi]
:
Each time you select, the setting is enabled/disabled.
■
Connecting to access point
1
In the main menu, [Settings]
/
[Transmission]
/
[Wi-Fi
settings]
:
Available access points are displayed under Wi-Fi networks when
Use Wi-Fi is enabled.
:
When the desired access point is not displayed, perform Easy Wi-Fi
registration or Add Wi-Fi network to register an access point.
2
Select the access point to use
3
[Connect]
:
For the access point with security set: Enter a password
/
[Connect]
■
Terminating connection
1
In the main menu, [Settings]
/
[Transmission]
/
[Wi-Fi
settings]
2
Touch the connected access point for a while
/
[Forget network]
/
[Yes]
:
When you want to terminate the connection retaining the password,
disable Use Wi-Fi.
Register AOSS/WPS-compatible access point with each method.
Enable Use Wi-Fi in advance.
The registration process takes a few minutes. After completion of the
registration of the access point, check that the proper connection to the
access point is acquired.
■
Registering with AOSS method
<AOSS method>
1
In the main menu, [Settings]
/
[Transmission]
/
[Wi-Fi
settings]
/
[Easy Wi-Fi registration]
/
[AOSS method]
2
Set your access point to AOSS mode
/
[Yes]
3
[OK]
■
Registering with WPS method
<WPS method>
1
In the main menu, [Settings]
/
[Transmission]
/
[Wi-Fi
settings]
/
[Easy Wi-Fi registration]
/
[WPS method]
2
Select a registration method
;
[Push-button method]
/
set your access point to WPS mode
/
[Yes]
Using Wi-Fi
When you terminated the connection with Use Wi-Fi disabled, enable
Use Wi-Fi to connect automatically if the previously connected access
point is available.
Registering access point at home
<Easy Wi-Fi registration>
nb10_e.book 218 ページ ２０１０年７月８日 木曜日 午前８時３３分
