Docomo foma SO705i, Instruction Manual

Page: 76 / 485

74
V
o
ic
e
/V
id
e
op
ho
ne
C
a
ll
s
6 Position the FOMA terminal
In remote monitoring, the image from the front
camera is sent to the dialing phone.
Put the receiving FOMA terminal on the
monitoring position, ensuring that it is switched
on and unfolded.
If the FOMA terminal is left folded, only the voice
is sent and the camera image is not sent. The
substitute image is sent with “
カメラオフ
Camera Off” written on the image.
Other ID screen (p.73)
Look-up address
……
Enters the address referring to the
phonebook, Dialed or Received calls records.
Delete this ・ Delete all …… Deletes one or all other ID(s).
When all IDs are deleted, the “Set” setting is set to “OFF”.
Starting/ending the remote monitoring
z
To perform remote monitoring, you should always
make a videophone call with caller ID (phone
number) notification provided from the FOMA
terminal registered as the other ID on the receiving
phone.
1
Make a videophone call to the
receiving phone
After the ringing time set on
the receiving phone has
elapsed, remote monitoring
begins.
The video image from the
receiving phone is displayed
and the sound comes from
the speaker on the dialing
phone.
■ To answer a videophone call on the
receiving phone without triggering remote
monitoring
Press
r
before the set ringing time is not
elapsed
To answer with a substitute image, press
d
(Subst.).
2 To end the call, press
y
The call duration is displayed and remote
monitoring ends. You can also end remote
monitoring by pressing
y
on the receiving
phone.
N
z
When positioning the FOMA terminal, set “Video-
phone” in “Vibrator” to “OFF” to prevent the FOMA
terminal from moving when receiving calls.
z
If the ringing time set for “Voice Mail Service” and “Call
Forwarding” on the receiver side is shorter than the
ringing time set for remote monitoring, “Voice Mail
Service” and “Call forwarding” take priority.
Front
camera
Adjust the angle
Dialin g phone
N
z
Calls can be received as a remote monitoring call
even when Dial lock or Omakase Lock is set.
z
Remote monitoring is not available when the following
functions are set:
• Public mode (Driving mode)
• Manner mode
• Call rejection/acceptation
*
• Reject unknown
*
*: When “Call acceptation” is set for a phone number
other than the other ID phone number or “Call
rejection” is set for the other ID phone number, or
when “Reject unknown” is set and the other ID
phone number is not stored in the phonebook
z
Specific ring tone for Remote monitoring is used and
cannot be modified.
z
Ring tone is played at the volume set in “Videophone”
in “Ring volume” (if the ring volume is set to “Silent”,
“Level 1” or “Step”, the volume is set to “Level 2”).
z
You cannot put the call on hold while receiving a call
for remote monitoring. Press
y
to end the call.
z
You cannot switch cameras from the receiver during
remote monitoring.
Please be considerate of the privacy of
individuals around you when taking and
sending photos using camera-equipped
mobile phones. Improper use of the FOMA
terminal in ways that constitute a serious
public nuisance may be punishable under
laws or ordinances intended to prevent such
behavior (privacy protection laws, etc.).