Docomo foma SO705i, Instruction Manual

Page: 450 / 485

29
Enter any connection name you want and click " ユーザ ID・パスワードの設定 " (Set up User ID/Password).
Enter the user ID and password, and follow the onscreen instructions to configure the settings. You can leave
the user ID and password blank for mopera U or mopera.
If your provider has given you instructions for setting IP and DNS information, click "
詳細情報の設定
" (Detailed
settings) on the "
パケット通信用ダイヤルアップの作成
" (Create dial-up for packet communication) screen,
register necessary information and click "OK".
After entering the settings, click "FOMA
端末へ設定を書き込む " (Write settings into FOMA terminal), confirm
overwriting and start writing.
Setting up Dial-up Network
This section describes how to set up a dial-up connection for packet communication / 64K data
communication without using the FOMA PC setting software. The flow of operation is described
below.
d
It is unnecessary to set up the dial-up network for 64K data communication. Go on to "Setting up Dial-
up" (p.36).
About AT commands
d
AT commands are commands for modem control. The FOMA terminal complies AT commands and
supports some enhanced commands and its own AT commands.
d
Entering an AT command allows you to set or confirm (display) the detail settings and the contents of
the settings for the "Data communication" and FOMA terminal.
Checking the COM port
d
To set up the access point (APN), you need to specify the COM port number assigned to "FOMA
SO705i" (Modem) built in after installing the FOMA communication setting file (drivers). This section
describes how to confirm the COM port number. The COM port confirmed here will be used in the
access point (APN) set up (p.32).
d
Preparation
1
Connect the FOMA USB Cable with Charge Function 01/02 (optional) to the
FOMA terminal
2
Turn on the FOMA terminal, then connect the FOMA USB Cable with Charge
Function 01/02 connected to the FOMA terminal to your PC
NOTE
d
The APN settings (the access point for FOMA packet communication) are stored in the FOMA terminal. Therefore,
the APN must be registered again if you connect to another FOMA terminal.
d
When continuously using the dial-up setting created on the PC, register the same APN setting (cid setting) number
with the FOMA terminal.