Docomo FOMA SH906i, Instruction Manual

Page: 248 / 596

246
e11_dv55_7e.fm
[246/252]
i-
a
pp
li
Press
c
to operate i-
a
ppli set as the stand-by display. The i-
a
ppli
stand-by settings are not disabled, and the i-
a
ppli stand-by is
restarted when the stand-by display reappears.
Set whether to transmit from the software set as the i-
a
ppli
stand-by, using Stand-by network set (
n
P. 247).
1
In the software list screen, select software
/ C /
[Stand-by display]
/
[Yes].
When the software using a transmission is set, a screen asking
whether to allow a transmission appears. Select [Yes] to allow a
transmission. When [No] is selected, data is not allowed to
transmit and information may not be received.
Disabling the i-
a
ppli stand-by settings
In the software list screen, select software set as stand-by
/
C /
[Stand-by display]
/
[Yes].
Depending on the software settings, the software may start
automatically after downloading is complete. In such cases, the
software cannot be saved to the FOMA terminal immediately after
downloading. After ending the software, select whether to save the
software if available.
Network set (
n
P. 233) may be required while i-
a
ppli software is
running.
i-
a
ppli To from i-mode mail is a function only available from i-mode
mail delivered from an IP (Information Provider). Not available for
i-mode mail exchanged between FOMA terminals.
i-
a
ppli stand-by
Setting i-
a
ppli as the stand-by
display
Note
Only one software can be set as i-
a
ppli stand-by.
Some software cannot be set as i-
a
ppli stand-by.
If i-
a
ppli stand-by is set, i-
a
ppli appears as stand-by. The image
set as the stand-by display of Set screen does not appear. If
i-
a
ppli stand-by is disabled, the image set as the stand-by display
of Set screen appears.
Web To functions are not available from i-
a
ppli stand-by.
If software that transmits data is set as i-
a
ppli stand-by, the
software may not operate properly depending on the signal
strength.
If All lock is set when in i-
a
ppli stand-by, i-
a
ppli stand-by display
closes and [ 待受画面 1] appears.
When the FOMA terminal is set to the viewer position, it appears in
the horizontal screen. The stand-by display appears, and the
software is interrupted depending on the i-
a
ppli software. Return
to the normal position to resume the software.
If i-
a
ppliDX is set as i-
a
ppli stand-by, the i-
a
ppliDX software may
transmit data to verify the validity of the software regardless of the
software transmission setting.
If i-
a
ppli stand-by is set, the i-
a
ppli stand-by confirmation screen
appears when the handset is turned on. Select [Yes] or do nothing
for approximately 5 seconds to start i-
a
ppli stand-by. Select [No]
to show normal stand-by and cancel i-
a
ppli stand-by settings.
However, when the handset is turned on by the Auto power ON
setting, the confirmation screen does not appear and i-
a
ppli
stand-by starts when the stand-by display reappears.
i-
a
ppli stand-by is not available when the 2in1 mode is set to [Dual
mode] or [B mode].
dv55_E.book 246 ページ ２００８年５月６日 火曜日 午前８時５９分