Docomo FOMA SH906i, Instruction Manual

Page: 120 / 596

118
e06_dv55_7e.fm
[118/126]
So
un
d/
Scre
en
/L
ig
ht Se
ttin
g
s
2
Select an item
/ t
.
3
Select the setting
/ t
.
To change the setting in [Normal]: Enter the light duration
/ t
.
Turn off the display when the FOMA terminal is not in use for a set
length of time.
1
In the Custom menu, select [Settings]
/
[Disp/LED/
Power saver]
/
[Light/Power saver]
/
[Original Eco
mode]
/
[Screen dsp time].
2
Select the time
/ t
.
Adjusting methods are as follows.
1
In the Custom menu, select [Settings]
/
[Disp/LED/
Power saver]
/
[Light/Power saver]
/
[Original Eco
mode]
/
[Brightness].
2
Select the adjusting method
/ t
.
When in [Manual]: Select [Manual]
/
adjust the brightness with
u / t
.
Note
Note that increasing the light duration shortens the continuous
stand-by time.
Light duration is prioritized as follows when multiple are set.
• If Videophone is used while i-
a
ppli is being activated, Display
light time for Videophone is prioritized.
• When Charging is set to [Always ON] and Videophone is used
while charging, Display light time is set to [Always ON]
regardless of the setting for Videophone.
Setting the Screen display time
<Screen dsp time>
Note
When the display is turned off, press a key to show the screen.
During i-Channel ticker playback, the display is turned off
according to the screen display time setting. However, when the
Screen display time is set to [30 seconds], the display remains for
approximately 60 seconds.
Priority (high
b
low)
Light
duration i-
a
ppli
b
Videophone/Internet
b
Charging
b
Normal
The display is not turned off even when the Screen display time
passes in the following cases.
Videophone calls are in progress
i-mode transmission is in progress
Mail is being sent/received Camera is being activated
i-motion is being played *1 Slideshow is being played
GPS positioning is being performed
Data is being transferred with an external device
PushTalk transmission is in progress
1Seg is being watched/recorded *2
Video is being played *2 Desktop clock is being shown
*1 Excluding Stand-by i-motion.
*2 Excluding when using Multi Window.
Adjusting the display brightness
<Brightness>
Automatic Adjust the display brightness automatically according
to the surrounding light. Keypad light is automatically
switched between Light and OFF when Keypad light
setting is set to [Light].
Manual Select from 16 display brightness levels. Check the
brightness while adjusting it.
Note
Note that increasing the brightness shortens the continuous
stand-by time.
dv55_E.book 118 ページ ２００８年５月６日 火曜日 午前８時５９分