Docomo Foma P700i, Manual

Page: 79 / 565

76
Making/Receiving
Video-phone
Calls
● Note that when you make a video-phone call while sending a substitutive image, you will be charged for the digital transmission.
●
You can make video-phone calls to any DoCoMo video-phone, no matter the type.
●
If you dial 110, 119 or 118 using the video-phone function, the number will automatically dial out as a voice call.
●
You cannot receive mail and Messages R/F during video-phone calls. Incoming mail and Messages R/F will be held at the i-mode
Center. You can retrieve them using “Check new message”, when you end the video-phone call. However, you can receive the Short
Message (SMS) during a video-phone call.
●
During Hands-free use, be sure to keep the FOMA phone away from your ears. Otherwise, you could affect or damage your hearing.
●
If the battery runs low during a video-phone call, the message “Recharge battery” appears and the substitutive image is sent to the
other party. However, if you set Chara-den for a substitutive image, the “Pre-installed” substitutive image is displayed. If you charge
the battery during a video-phone call, the image set for “Substitutive image” of “Select image” is displayed.
●
You cannot dial video-phone calls by entering the phone number when “Keypad dial lock”, “Restrict dialing” or “Self mode” is
activated.
●
The International Video-phone call is available using the DoCoMo International Call Service “WORLD CALL”. (See page 50)
Information
■
Auto-redialing
If the video-phone call is not connected, dialing at 32K or the voice call is automatically made.
●
The video-phone call by 32K speed is provided to connect with PHSs and similar devices that cannot connect at 64K depending on
the network conditions. When you dial a 64K video-phone call to a phone that can only connect at 32K, the dialing speed will be
switched automatically to 32K.
※
The same digital transmission charge applies to the 32K video-phone connection and 64K digital connection.
●
Video-phone calls cannot be connected to phones if they do not support the video-phone function, are out of the service area, or
are switched off. If you have set “Voice call auto Switch” to “ON” and attempt to dial a phone that does not have the video-phone
function, the video-phone call will be cut off and the number will be redialed as a voice call. Note that this setting might not work if
you call an ISDN synchronous 64K or PIAFS access point or an ISDN video-phone that does not support 3G-324M (as of January
2005), or if you dial the wrong number. Nevertheless, you could be charged for the call.
●
Once the video-phone call has started communications, redialing as the voice call will not be made.
Voice call auto SW “ON” Voice call auto SW “OFF”
Could not connect by dialing at 64K. Dials again at 32K. Dials again at 32K.
Could not connect by dialing at 32K. Dials again by the voice call. Does not dial again.
While entering a phone number ( ) Do the following operation.
1
Function Menu while entering Phone Number
Function menu
Notify caller ID
Prefix numbers
International dial
Multi number
Add to phonebook
Compose message
Dialing speed
Select image
Operations
You can select whether to notify caller ID. (See page 45)
You can add prefix numbers. (See page 58)
You can make international calls. (See page 52)
See page 436.
You can store data in the Phonebook. (See page 97)
You can compose a message to send to the phone number set as a mail address.
Go to step 3 on page 235.
You can set the dialing speed per call for a video-phone call.
64K··················For dialing video-phone calls at 64K.
32K··················For dialing video-phone calls at 32K.
You can select an image for video-phone calls. (See page 86)