DoAll ZV-3620, Instruction Manual

Page: 34 / 37

30
ACCESSORIES
The following are accessories sometimes
used during sawing operations. A DoALL
sales representative can advise you about the
current availability of any accessory.
DISC CUTTER
1. This attachment can be used to cut internal or
external circles from 3 to 36 inches (76.2 to 914.4
mm) in diameter. To set up the disc cutter:
• Place flat washers under the mounting screws. Then:
(a) Bolt the mounting bracket to the post; (b) Lower
the post until the upper saw guide is approximately
3/8 inch (10 mm) above the worktable; (c) Loosen
the fine adjustment and arm clamp bolts; (d) Move
the center pin to the approximate distance of the
radius to be cut; (e) Tighten the fine adjustment
clamp bolt.
Disc Cutter.
• Position the center pin so that it is perpendicular to
the saw band’s cutting edge. To do so: (a) Place
a square against the tip of a sawband tooth; (b)
Loosen the vertical adjustment clamp bolt; (c) Line
up the center pin with the square’s blade edge; (d)
Clamp the vertical adjustment clamp bolt.
• Make final radius adjustments with the fine
adjustment wheel. Then: (a) tighten the arm and
radius arm clamp bolts while making sure the center
pin is square to the table; (b) Adjust the disc cutter
for stock thickness by raising or lowering the post.
RIP FENCE
1. Square this fixture during installation so that it is in
line with the worktable sawing slot. When alignment
is correct, secure the adjusting screws in place with
the set screws under the the guide bar on the rip
fence casting.
2. Before attempting a long cut, check to see that the
saw band is not worn on one side. This will cause
stock to wander relative to the rip fence guide bar.
Rip Fence.
WORKLAMP
1. This worklamp illuminates the cutting area and areas
nearby. It is turned “OFF” and “ON” with a switch
on the lamp itself.
• Some machines may have a selector switch located
on the pushbutton control box on the front of the
control box enclosure to turn the lamp "OFF" and
"ON".
MAGNIFIER
1. Magnifing the cutting area may prove helpful
during delicate sawing procedures. This is done
by placing a magnifing lens around the shade of
the worklight.
2 . A protective lens cover should be placed around
the magnifier to prevent scratches when not being
used.
CHIP BLOWER
1. A nozzle delivers shop air to the sawing area. The
operator can remove chips and depris from the
sawing area by adjusting the flexible hose and
nozzle.
2. Incoming air supply should be betwwen 80 to 90
psi (5.5 to 6.2 bar or 5.6 to 6.3 kg/cm²) is required
to operate this option.
DO NOT exceed 90 psi (6.2 bar or 6.3 kg/cm²)
air pressure.