17
Using theTensigage.
3.
A DoALL Tensigage can also be used to check
the band tension. A reading of 2.2 units indicates
correct band tension.
4.
Tension may be checked “reading up” or “reading
down”.
(a)
Fix the Tensigage to a slack saw band
and apply tension to “read up”.
(b)
To “read down”,
relax tension.
5.
A new saw band will stretch as it being used. For
this reason, it is adviseable that the operator checks
the band tension frequently.
6.
The following are operator tensioning
recommendations:
•
Reduce
the recommended band tension when
using saw bands with a coarser pitch or lighter
gage.
•
Increase
the recommended band tension when
using heavier gage saw bands.
POST ADJUSTMENT
1.
Post elevation can be adjusted to accept workpieces
under saw guides with heights varying up to the
limits of the saw depending the work height capacity
(standard capacity is 20 inches (508.0 mm). The
post is positioned with a selector switch located
on the pushbutton control box on the front of the
machine.
2.
Always keep the post and upper saw guide as close
as possible to the workpiece and the post band
guard in place at all times when in operation.
SPARK GUARD
1.
A spark guard is provided for protection from chips
and sparks. It is installed over the saw guides and
clamped to the place with a wing nut.
WORKTABLES AND ADJUSTMENTS
1.
The standard worktable measures 36.25 by 30.5
inches (920.7 by 774.7 mm). Its load capacity is
500 pounds (226.8 kg) evenly distributed with NO
impact.
The machine must be bolted to the floor for
table loads over 100 pounds (45.4 kg)
.
Standard Worktable.
2.
The worktable can be tilted manually up to 5° left
and 45° right primarily for sawing compound angles.
The amount of worktable tilt is indicated by a pointer
and a trunnion-mounted calibrated scale.
3.
To tilt the worktable:
(a)
Move the table tilt locking
lever located just above the locking handwheel to
the left to loosen;
(b)
Turn the handwheel located
under the table to desired angle as indicated on the
scale;
(c)
Move the tilt locking lever to the right to
tighten.
4.
The worktable is drilled and tapped on the front side
for attaching accessory equipment. Its removable
table filler plate can be locked in place by two (2)
knobs located under the table.
Optional Secondary Table
1.
The fixed worktable measures approximately 19.00
by 19.00 inches (482.6 by 482.6 mm) and used for
support of large workpieces.
Optional Hydraulic Table
1.
Another optional hydraulic table measures 32 by 41
inches (812.8 by 1041.4 mm) with a table stroke of
16 inches (406.4 mm) and hydraulic actuated table
tilt. See the
“Accessories”
section of this manual
for operation of this table.
SAW BAND PREPARATION (Continued....)
Summary of Contents for ZV-3620
