DoAll ZV-3620, Instruction Manual

Page: 16 / 37

12
10. Add or remove shims under the base pads until the
correct post to square clearance is obtained.
11. With an indicator mounted to the saw guide post,
check table travel by positioning the indicator to
read off of the T-slot in the table. Traverse the table
through its full travel and adjust to achieve from 0
to .015 inch per 30 inches (0 to 0.38 mm per 762.0
mm) of travel.
12. When table and machine are in correct alignment
and level, tighten the mounting screws and then
tighten the jam nuts on the leveling bolts.
PREPARATION FOR USE
1. Remove the pipe plug from on top of the upper
spindle for venting purposes,
not
the two (2) from
the side and bottom of the spindle.
2. Be sure the hydraulic reservoir is full. Refer to the
Lubrication Chart for recommended fluid.
• If necessary, replace the plug on top of the reservoir
with the breather from the box of extra parts.
3. Shop air is required to operate the optional chip
blower or band lubricator. Incoming air supply should
be between 80 and 90 psi (5.6 and 6.3 kg/cm²).
DO NOT exceed 90 psi (6.3 kg/cm²).
4. Check the optional band mist lubricator unit for the
proper reservoir level. Refer to the manufacturer
supplied literature for reservoir capacity and
recommended procedures.
5. Make sure all other points listed by the Lubrication
Chart have been properly checked and/or
serviced.
TABLE ALIGNMENT (HMD Table) (Continued....)