16
Insert-Type Saw Guide Adjustment
These instructions apply to both the upper
and lower insert-type saw guide blocks.
1.
Select the saw guide blocks and inserts marked
for the width of the saw band to be used. Then:
(a)
Place the right insert in the right milled slot;
(b)
Tighten the insert screw slightly so that the insert
will slide in the slot, yet still hold its correct position
when released.
Positioning the Right Insert.
2.
Select the insert gage which matches the size of the
saw band being used. Then:
(a)
Place the insert
gage in the left slot;
(b)
Adjust the right insert to fit
exactly into the notched end of the gage;
(c)
Tighten
the right insert screw.
3.
Place the left insert in its slot and tighten the insert
lightly. Then:
(a)
Place the gage edgewise between
both inserts;
(b)
Lower the left insert until it rests
against the gage;
(c)
Tighten the left insert screw.
Positioning the Left Insert.
Saw Band Removal
Always use extreme care when handling saw
bands. Wear gloves.
1.
Turn the band tension handwheel to release saw
band tension. Then:
(a)
Open both bandwheel
doors;
(b)
Open the post and the column saw
band guards;
(c)
Loosen the knobs holding the
worktable’s sawing slot filler plate and remove it.
2.
Carefully slip the worn or broken saw band from
between the saw guides rollers or inserts and table
slot and remove it from around both bandwheels.
Saw Band Installation
Always use extreme care when handling saw
bands. Wear gloves.
1.
Remove the old saw band according to the
directions above. Then:
(a)
Place the new saw
band carefully (teeth facing down and to the front)
through the table slot, around the bandwheels and
between the upper and lower saw guide rollers or
inserts;
(b)
The center of the saw band should track
along the center of the bandwheel tires.
2.
Remove the new saw band’s protective Saw Cap.
Then:
(a)
Apply the band tension recommended
by the dial located on the front of the column;
(b)
Close the post and the column saw band guards;
(c)
Replace and secure the worktable’s sawing slot
filler plate.
Saw Band Tension Adjustment
1.
Saw band tension is adjusted by turning the
handwheel located below the machine’s sawing
head.
Optional hydraulic band tension is factory set.
DO NOT adjust the handwheel if supplied!
2.
A scale showing the recommended tension for
various saw band widths is located to the right of the
tension adjustment handwheel near the post. Scale
numbers represent the recommended tensions for
common saw band gages and pitches.
SAW BAND PREPARATION (Continued....)
Summary of Contents for ZV-3620
