DMC Hi Cap 54, Owner'S Manual

Page: 15 / 61

Step 20. Lift front end of drive shaft up
from brackets and place three
A-136 drum drive V-belts over
shaft. Then place two trash pan
auger drive belts (A-91) over the
two-groove pulley on the main
drive shaft located between the
bearings. Loosen the locking
collars holding the two front
bearings. Then bolt the bearing
flanges outside of the support
brackets using four 5/16” x 3/4”
carriage bolts, lock washers and
hex nuts. Finish by locking the
bearing collars in the direction of
the shaft rotation. Rotation would
be clockwise when viewed from
the front. See Photos 20 and 21.
Photo 19
Photo 20
Photo 21
Photo 22
Step 21. Install drum drive belt idler
assembly using one 5/8”
SAE flat washer and one
5/32” x 1” cotter pin. Attach
two extension springs to the
idler arm. See Photo 22.
6