DMC Hi Cap 54, Owner'S Manual

Page: 16 / 61

Photo 23 Photo 24
Photo 25
Photo 26
Step 22. Fasten motor belt shield back panel, using two 1/4” x 3/4” self-tapping
screws. Have the flange facing toward front. Slotted holes are provided in
case adjustment of the panel is necessary when the front drive belt shield is
installed. See Photo 23.
Step 23. Install 16” double-groove front drive pulley using 1/4” x 2-1/4” square key.
Place pulley on the shaft with hub out. Shaft must be brought through pulley
approximately 1/8” to be in proper position. Check alignment with motor
pulley. Securely tighten set screws. See Photo 24.
Step 24. Install two A-66 drive belts between motor and 16” pulley, and adjust tension
to the point that the belt will have approximately 3/8” deflection. See Photo
25. BE SURE MOTOR PULLEY AND 16” PULLEY ARE PROPERLY
ALIGNED. TIGHTEN 3/8” X 5” BOLT HOLDING MOTOR MOUNT.
Step 25. Place 1” locking collar on to 10” ribbon auger shaft. Pull shaft through
bearing until 7-1/4” of shaft is protruding past the lock collar in direction
auger turns (clockwise). See Photo 26.
7