DMC Hi Cap 54, Owner'S Manual

Page: 21 / 61

Step 39. TRASH CHUTE SCREEN: (a) May come installed from the factory, or; (b) to
install, connect screens to main drum ring, with eight screen clamps and eight
self-tapping #10 x 3/4” washer head screws as shown in Photo 41.
Step 40. Slide spacer tube to short end of drum axle. Then, slide drum axle through
front drum bearing with bearing collar to the outside. After pressing bearing
and spacer bushing against axle disc, place bearing locking collar to shaft
and lock collar in opposite direction of drum rotation. See decal on front of
drum ring for rotation.
Step 41. Place tumbling bar support
ring approximately half
way on to cone drum.
Next, slide center drum
ring and bearing locking
collar to drum axle
shaft with bearing collar to
outside. Leave locking
collar loose at this time.
See Photo 42.
Step 42. Slide rear drum ring and
locking collar on drum axle
shaft, with bearing lock
outward. Do not set lock-
ing collar at this time. See
Photo 42.
Step 43. Bolt drum rings together with tumbling bars. Place tumbling bars to the inside
of the drum rings. Secure with 1/4” x 5/8” hex flange-head screws and hex
flange locknuts. DO NOT TIGHTEN TUMBLING BAR BOLTS FIRMLY UNTIL
DRUM HAS BEEN SQUARED. See Photos 43 and 44. Tumbling bar bolts
should be torqued to 120-inch pounds.
Photo 42
Photo 43
Photo 44
12