DMC Hi Cap 54, Owner'S Manual

Page: 40 / 61

HYDRAULIC DRIVE ASSEMBLY INSTRUCTIONS
HYDRAULIC DRIVE ASSEMBLY - 10” AUGER
Steps 1 through 5 - See Auger Assembly.
Steps 6 through 8 - Eliminate.
Step 9 - See Auger Assembly.
Steps 10 through 13 - Eliminate.
Steps 14 through 25 - See Auger Assembly.
- Continue on Page 32 -
For proper assembly procedure, the following steps must be followed:
Steps 1 through 4 - See Cleaner Assembly on Page 1.
Step 5 - Bolt front frame assembly to side channels, using seven 3/8” x 1” hex bolts, lock
washers and hex nuts. Leave bolt for front end of left side channel and front
frame side. Bolt will be installed later in the assembly.
Steps 6 through 16 - See Cleaner Assembly.
Steps 17 and 18 - Eliminate.
Steps 19 through 22 - See Cleaner Assembly.
Steps 23 and 24 - Eliminate
Steps 25 through 28 - See Cleaner Assembly.
Step 29 - Hydraulic drive has plate with one inch wood bearing only. Secure as stated
in Step 29, Photo 36 of the Cleaner Assembly.
Step 30 - Eliminate.
Steps 31 through 69 - See Cleaner Assembly.
Step 70 - Eliminate.
Step 71 - See Cleaner Assembly.
- Continue on Page 32 -
31