DMC Hi Cap 54, Owner'S Manual

Page: 26 / 61

Step 61. Determine what side of
Model 54 5” trash auger is to be
mounted. Insert lower section of
5’ trash auger into trash pan
bottom near front. Attach to side
channel of cleaner using three
3/8” x 1” hex bolts, SAE flat
washers, lock washers and hex
nuts. See Photo 58.
Step 62. Two 5’ auger positioning holes are
provided in the bottom of the trash
pan. After the 5” lower section of
the auger has been installed, close
the opening which has not been
used with small galvanized cover
and two 5/16” lock washers and hex
nets. See Photo 59.
Step 63. Attach the two threaded shock
mounts to the gear drive assembly,
using the two lower holes IF the
trash auger is mounted ON THE
RIGHT SIDE OF THE CLEANER.
(See Photo 60) If on the left side,
use the two upper holes.
Secure threaded shock mounts into
the drive assembly with 5/16’ lock
washer and hex nut.
Step 64. Position the two shock mount rings
over the rubber shock mounts and
secure the shock mounts to the
gear drive assembly support
bracket with a 5/16 inch flat washer,
a lock washer and a hex nut. (See
Photo 60)
Photo 60
Photo 59
Photo 58
17