DMC Hi Cap 54, Owner'S Manual

Page: 19 / 61

Step 35. Place the three flow rings over cone drum axle. Continue by bolting the small
cone ring to the drum axle using three 3/8” x 1” hex bolts with lock washers and
hex nuts. See Photo 34.
Step 36. Bolt six screen support bars to cone rings, using twelve 1/4” x 5/8” hex flange
screws and hex flange lock nuts. Bolt bars underneath cone ring flanges with
slotted end of bar attached to the small ring. Tighten securely. See Photo 35.
Step 37. To attach cone flow rings to the screen support bars, bolt angle bracket to
cone flow rings using shortest end of angle. Proceed to bolt cone flow rings to
the screen support bars with the longest end of the angle pointing toward inlet end
of drum. See Photo 36. The entire operation requires eighteen
1/4” x 5/8” flange head screws and flange lock nuts. See Photo 36.
BOLT CONE FLOW RINGS TO ALTERNATE SCREEN SUPPORT BAR. (See Photo 37)
Photo 34
Photo 35
Photo 36
Photo 37
10