DMC Hi Cap 54, Owner'S Manual

Page: 17 / 61

Step 26. BOLT, BUT DO NOT TIGHTEN, the adjusting plate with two 5/16” x 1” hex bolts,
5/16” flat washers, lock washer and hex nut. Position the lower bolt on the
opposite side of the 5” trash auger.
Step 27. Place the 28 tooth sprocket on the trash pan auger shaft using 1/4” x 1-1/4”
square key. Position sprocket, hub outward, so there is 2-3/8” distance from the
front mounting plate to the center of the sprocket teeth.
Step 28. Place 8” cast two-groove pulley on to trash pan auger shaft, using 1/4” x 2”
square key. Position pulley 4-5/8” from the front of the trash pan panel to the
center of the first groove from panel. Securely tighten set screws. Place the two
A-91 belts, installed in Step 20, over the trash pan auger shaft. See Photos 27
& 28.
Step 29. Bolt front switch box plate with 1” wood bearing for trash auger shaft into
position using four 1/4” x 5/8” flanged head screws and hex flanged lock nuts.
(Should wood bearing need alignment, bolts holding bearing may have to be
loosened) See Photo 28.
Step 30. Insert wire for three-horsepower motor through flared hole at lower end of front
brace extension. Push through center of tube and out the top. Connect to the
motor, using water-tight connector. Correct rotation is clockwise when looking at
motor shaft in mounted position.
Step 31. Bolt the 3-1/2” flanged idler pulley for
A-91 belts into position using 3/4”
spacer, 1/2” x 3” hex bolt, two flat
washers, lock washer and hex nut.
Place the 3/4” spacer between the
mounting bracket and pulley with one
flat washer on each side of adjust-
ment slot. Finish by putting the A-91
V-belts on to pulleys and tighten belts
to approximately 3/8” deflection. See
Photo 29. Check alignment of pulleys
and idler.
Photo 27
Photo 28
Photo 29
8