OPERATING PROCEDURE
The following rules
must
be observed when using the
Steam ‘N’ Vac
•
Always
Check daily before use that the power supply cable, plug
and sockets are in good condition; check for visible signs of
damage (do not use if damaged)
•
Never
allow any part of the
Steam ’N’ Vac
to be immersed
in water
•
Always
Follow the correct procedure when filling the water
reservoirs and waste tank
•
Never
allow children, inexperienced, untrained or
unauthorised people access to the
Steam‘N’ Vac
•
Always
Wear full PPE when working in confined spaces - mask,
goggles, gloves, overalls
Operating Procedures on the Steam ‘N’ Vac
Unclip handle
Remove transparent
cover
Remove waste
bucket
Fill with cold water
between minimum
and maximum mark
Replace bucket
cover and handle
Remove reservoir
filler plug
Fit funnel and fill with
2 ltr of cold tap
water. Replace
reservoir filler plug
Press the steam
peddle switch once,
the amber light will
start to flash
Wait approximately 4
minutes until the
amber light is steady
Open the front panel
and connect the
steam hose
Plug the power cable into a
suitable electric socket.
Press the on / off switch on
the back of the machine
Turn the steam
control knob to
required setting
