dixell xweb 5000, Operation Manual

Page: 12 / 115

XWEB5000 Operation Manual
12/115 1592010600
2.1.6 COMPATIBLE INSTRUMENTS
For a more complete list please read Appendix D.
2.1.6.1 PARTICULAR DEVICE SETUP

All controllers equipped with 2 serial addresses (XC400/600/800/900, XH200/300/400 etc.) must be used
with both addresses equal.

iCHILLs need to activate a particular value in the “Advanced” section. User must check “Force Device On
status”. Remember to stop-start acquisition after this operation.

To use non Dixell, but modBus compatible controllers (such as Energy Analyzer by Carlo Gavazzi) follow
this instructions:
a) Go to “Devices” and choose a controller.
b) Push “Add”. A new controller on the same address will be added.
c) Modify the serial address to match the one of the new controller. Push “Confirm”.
d) Go to “Advanced” and with “Model” menu select the correct model. To complete the previous example,
to insert Energy Analyzer “WM22-DIN-AV5” choose “ENERG.ANAL”.
e) Check “ Force Device On status” and all the other categories needed such as “Device Type” and
“Sampling”. Push “Update”.
2.1.6.2 XEV MANAGEMENT
The XEV driver for the electronic expansion valve On/Off can be linked together with a controller.
a) Enter the programming mode of the XEV and set Mod=AdU
b) Set the Adr to the same value of the controller the XEV is linked to.
c) Make a “device find” on the XWEB, only the controllers will be added to the setup. XEV will not be available
during this phase.
d) Enter devices and pick up the first device that has been linked to the. Go to Advanced section and make a
model change according to the following chart:
DEVICE XEV MODEL TO USE
XM463 ver. 0.2 XEV ver.0.3 XEV (0.2+0.3)
XM466 ver. 1.2 XEV ver.0.3 XM466+XEV (1.2+0.3)
XR570D ver. 2.0 XEV ver.0.3 XEV (2.0+0.3)
Press confirm (see APPENDIX: ADVANCED SECTION).
e) If you must add more than 1 controller, you can use the clone function.
Go to device, then press “Clone”.
The function starts, a pop-
up appears, press “cancel”. This function will assign the model you have just setup
to all the others that are present in the setup.