Connecting the Coaxial Cables
4
With the dome mounted securely to the back of the cab, you are ready to install the coaxial
cable. It is important to note, that coaxial cables are easily damaged and inoperable if kinked
or pinched in any way.
*Be very careful not to kink or put them in a place that will pinch these cables.
1.
Apply a small dab of dielectric grease to each
coaxial connector on the 29’ Dual Coaxial Cable,
then connect the coax with the white writing on it
to the main port on the dome. Connect the other
coax line without writing to the secondary port of
the dome.
*If installing the single coax included with the
EpicVue basic package connect it to the main
port.
Feed this coax across the sleeper and down
through the wind-fairing brackets.
2.
Now it’s time to run the wires into the sleeper.
Find a spot where the wire can come up through
the bottom of the sleeper cab. Some trucks already
have a factory cutout, which can be used.
Pull up the padded liner and find the best place
to drill the cable entry hole in the bottom of the
sleeper.
11
Coax Behind & Through
Bracket
Connecting the Coaxial Cables
www.TVformytruck.com/installation
