Add flex tubing around the cables to prevent them
from rubbing and shorting out. Use a zip tie or two
underneath the sleeper to prevent the coax from
hanging down and catching on something.
Drill a 1-1/8” hole using a step bit or a hole saw.
Next run the cables through the hole, making sure
they are pulled tight (without kinking the cable).
3.
Once you have run the cables into the cab, pick
a route to run the cables to the entertainment
center.
*Every setup is unique, as some cabs have
cabinets with refrigerators and/or microwaves.
Choose a path that has little disruption and
minimal alterations to the current configuration.
Whatever you do, do not put the cables in a
location where they could potentially get kinked
or pinched. This will prevent satellite signal from
reaching the receiver, and you will not get any
picture.
12
Connecting the Coaxial Cables
www.TVformytruck.com/installation
