Dionex ASE 150, Operator'S Manual

Page: 53 / 176

3 • Operation and Maintenance
Doc. 065207-02 9/08
45
3.2.6 Completing the Run
1. Verify that a collection vessel and a waste bottle are installed (see
Section 3.1.6 and Section 3.1.7 ); the needle switch is down; and the
cell, collection vessel, and waste bottle doors are closed.
2. Press
START
to begin the run. A typical run takes 15 to 25 minutes.
3. Monitor the run on the
STATUS
screen (see Figure 3-14 ).
4. When the run is complete, three beeps are emitted, the
START
LED
turns off, and the
STATUS
screen displays
IDLE
.
5. Toggle the needle switch to the
UP
position and remove the collection
vessel containing the extract from the holder. Refer to Section 3.3 for
post-run procedures.
6. Put on the thermal gloves (P/N 060372) provided in the ASE 150
Ship Kit (P/N 066399).
7. Remove the cell from the cell holder and place it on the cell rack
(P/N 059927) to cool.
8. Close the cell door until the next run, to save energy and prevent
anyone from accidentally touching a hot surface.
Do not attempt to open the cell door while a run is in progress.
N'ouvrez pas la porte pendant une extraction.
Halten Sie die Tür während der Extraktion geschlossen.
Cells are extremely hot after a run. Be especially cautious with cells
that have been heated over 50 °C (122 °F).
Les cellules sont extrêmement chaudes après une extraction. Faites
particulièrement attention aux cellules qui ont été chauffées à plus de
50 °C.
Die Zellen sind nach ihrer Entnahme sehr heiß. Seien Sie besonders
vorsichtig, wenn Zellen über 50°C erhitzt wurden.