Digital Projection
M-Vision 930 Series
CHANGING THE FILTERS
Installation and Quick-Start Guide
13
Rev A January 2014
Changing The Filters
The projector contains four identical replaceable filters accessible via the air inlets.
To replace the filters on the right-hand side of the projector:
1. Loosen the two screws on the cover of the air inlet and remove the cover.
2.
Pull out the old filters.
3.
Insert the new filters into the slots.
4.
Reattach the cover and tighten the screws.
Notes
Before changing the filters,
always make sure the projector
is switched off and fully
disconnected from its power
supply.
When changing the filters, avoid
using excessive force as this may
damage the equipment.
Summary of Contents for Titan 930
Page 8: ...Digital Projection M Vision 930 Series This page is intentionally left blank...
Page 39: ...Rev A January 2014 OPERATING GUIDE M Vision 930 Series High Brightness Digital Video Projector...
Page 70: ...Digital Projection M Vision 930 Series Operating Guide This page is intentionally left blank...
Page 83: ...Rev A January 2014 REFERENCE GUIDE M Vision 930 Series High Brightness Digital Video Projector...
