Digital Projection lightning series, User Manual

Page: 17 / 156

Safety Warnings
All the safety warning in this manual are in bold italic type and can be identified by
the symbol shown on the left. A list containing all the warnings is given below. It is
recommended that time is taken to study these before installing or operating the pro-
jector.
The projector should always be lifted using the handrail. Do not attempt to lift the
projector by holding the covers or the lens.
The customer should never attempt to disassemble the lamp from its housing or to
dispose of it other than by returning it to Digital Projection.
Do not move or tamper with any seals or ducting panels on the projector or the
air flow could be disrupted and cause the projector to overheat. Always keep the
air inlets and outlets clear of any obstruction.
High Voltage, Danger of Death - the arc lamp power supply has a 30kV strike
pulse mechanism, which is active during lamp switch-on.
The projector should never, under any circumstances, be operated on its side with
the lamp pointing upwards when viewed from the rear
To avoid possible damage to the prism, lens and lent mount, a lens adapter must
by used if using
POWER gv lenses on a LIGHTNING sx projector.
Never mount the projector near air conditioning or heating ducts, electrical
wiring or any materials which could be affected by the projector's operational
heat i.e. polystyrene ceiling tiles etc.
Never locate the projector where a laser beam may enter the lens, or fall on the
light engine otherwise catastrophic damage will result.
A—3
Overview
OVERVIEW
LBV00056; Revision C - 01/03/03