Step 13: Mounting the Status LED
13a – LED function and mounting
The iKEY system has a dual color (Red/Blue) LED that provides system status information, such as
when the system is Armed or Disarmed or when the vehicle security system has been violated.
Additionally the LED is necessary to program certain customizable system features. Although it is not
absolutely necessary to mount the LED where it is always visible, it is recommended. If you decide not
to mount the LED, be sure to leave it plugged in throughout system testing and then ziptie it securely
out of site.
There is no right or wrong location to mount the LED, but we suggest you mount it where it can
be seen from outside the vehicle. Also, be sure there is at least ½ inch or more of room behind
the panel location you select. Once you choose a location where you would like the LED to be
mounted, place a piece of masking tape over the area to protect surrounding surfaces, and then
mark the hole location to be drilled with a pen. Next use a 8mm or 5/16th drill bit and slowly drill
the hole. ( Pic 1). Then remove the masking tape and feed the LED wires through the hole and
snap the LED into place. Route the LED wire back to the Key module and plug it into the 3 pin
connector. Lastly replace the panel. ( Pic 2).
Summary of Contents for iKEY-M
Page 1: ...iKey M Passive Entry Keyless Ignition for 2010 2014 Mustang s...
Page 2: ......
Page 23: ...Connector C1 Factory Ignition Connector...
Page 28: ......
