Digital Guard Dawg iKEY-M, Manual

Page: 18 / 28

11c – Making Accessory Connections
For ease of access and to give yourself some room to work, it is easiest to unplug the connectors from
the SJB before making connections to them.
Begin by releasing the #1 Connector. Simply pull
the clip from the bottom of the connector upwards to release the locking clip of connector
(Pic1 ).
It often helps to wiggle the connector a bit to release it. (Pic 2 ). Once you have unplugged
Connector #1, peel back any electrical tape around the harness so you have 2” inches of wire exposed
to work with (Pic 2 ).
The Connections you will be making are listed on the Accessory Table below:
Notes prior to making connections;
The wire colors of both the Accessory Harness and the Factory Wires will match.
* except If you are
installing a mustang Convertible( the Trunk may be different.) (See wire #5)
. Make connections to wires
aproximately 1 in. below the factory connector. Do not pull on factory wires when making connections.
Make sure your Quick Connection “Snap” closed.
*** If you are unfamiliar with how to use a 3M® “T” Tap Connectors see instructions in using
T-Tap connectors, see YouTube Video: https://www.youtube.com/watch?v=ikZZBmvFEho