Digital Guard Dawg iKEY-M, Manual

Page: 8 / 28

2A: Separate Transponder chip from key blade
Using a Dremel drill or other cutting tool; cut the blade of the spare key off right where the shaft meets
the body. Use a file to remove any rough edges.
2B: Mount Transponder Key Head into Bypass Module
Attach a small square of double sided tape to the head of the spare key and remove the protective film
from the tape.
Next, remove the cover of the Bypass module by removing the 4 small Phillips screws on the back.
Next, insert the spare key head into the Bypass module as shown with the sticky tape side down. Press
firmly the key head in place to assure the head is secure.
Lastly, replace the Bypass Module cover.
STEP 2. Assemble Bypass Module
Overview: Inside the head of the every Ford key is a “RFID Transponder” this is a Radio Frequency ID
chip with a unique code. Your vehicle computer must read this code before it will allow your vehicle to
start. During Step 1, we programmed the code of the Spare key into your vehicles computer. Now we will
separate the head of the key with the RFID Chip inside and place it into the systems “Bypass Module”.
This module will send the ID code to your vehicles computer when you push the Start Button of your
iKEY-M system.
You will use the cut KEY BLADE later in Step 13