Digital Guard Dawg iKEY-M, Manual

Page: 11 / 28

Step 4: Access Ignition Harness Connector
4a Locate Ignition Connector
The Ignition Connector is attached to the back of the Ignition Switch. It can be accessed by reaching in
the opening behind where the lower steering wheel shroud was attached. It faces the firewall and can
be seen easier by looking up under the dash .
4b The WRONG Connector
There is a similar looking connector
that is to the left of the Ignition switch.
It is not attached to the Ignition switch.
This is the Wrong Connector!
4c Unplug the Ignition Connector
To release the Ignition Connector from the Ignition Switch Housing you will need to depress the locking
tab on the top of the connector. Grab the harness and connector and pull out firmly. Sometimes it helps
to wiggle connector as you pull.