Digital Guard Dawg iKEY-M, Manual

Page: 7 / 28

STEP 1. Cut and Program Spare Key
1a: Cut Spare key blank
Included in kit is a Spare Mustang Key Blank. You will be using this blank
to release the steering column lock as well as activate the Bypass module
of your system. Before you begin installing your system, you will need to
have the Ignition Key blank cut to fit your vehicles ignition switch. Most
any hardware store can do this for a couple dollars.
Please read and understand the entire procedure before you begin.
1. Insert the first currently programmed coded key into the ignition.
2. Turn the ignition from the 1 (LOCK) position to the 3 (RUN) position.
Keep the ignition in the 3 (RUN) position for at least three seconds, but no more than 10 seconds.
3. Turn the ignition to the 1 (LOCK) position and remove the first coded key from the ignition.
4. Within ten seconds of turning the ignition to the 1 (LOCK) position, insert the second currently coded
key.
5. Turn the ignition from the 1 (LOCK) position to the 3 (RUN) position.
Keep the ignition in the 3 (RUN) position for at least three seconds, but no more than 10 seconds.
6. Turn the ignition to the 1 (LOCK) position and remove the second currently coded key from the
ignition.
7. Within twenty seconds of turning the ignition to the 1 (LOCK) position and removing the currently
programmed coded key, insert the Spare un-programmed key into the ignition.
8. Turn the ignition from the 1 (LOCK) position to the 3 (RUN) position.
Keep the ignition in the 3 (RUN) position for at least six seconds.
9. Remove the newly programmed coded Spare key from the ignition. The theft indicator light will
illuminate for three seconds and then go out to indicate successful programming. (PIC 3)
10.
TEST: Use the new Spare key to start your vehicle. If the key has been successfully programmed
your engine will start.
1b: Program Spare key to vehicle
Next, follow the instructions below to program the new Spare key to the vehicles computer.
You can also check out this YouTube video that shows the programming process:
https://www.youtube.com/watch?v=Kz6935L6XFI
*** NOTE: YOU MUST CURRENTLY HAVE TWO WORKING / PROGRAMMED IGNITION KEYS TO
PREFORM THIS PROCEDURE. If you do not have two working/programmed keys, you will have to take
this remote key to a dealer or locksmith for programming.
* If you have a 2013 “Shelby” Mustang please call us before preforming programming.