Maintenance Manual Removal and Replacement
____________________________________________________________________________________________
4.3.17 Lower Feeder Assy
1) Remove the Main Rear and Front Covers (refer chapter to 4.3.4 and 4.3.5).
2) Remove the AGA motor (refer to chapter 4.3.10).
3) Remove the AGA support (refer to chapter 4.3.11).
4) Remove the cut sheet assy (refer to chapter 4.3.14)
5) Remove the circlip retaining the AGA gear to its pivot and remove the gear.
6) Unscrew the screw securing the AGA sector to the main shaft and remove it.
7) Remove the carriage motor assy (refer to chapter 4.3.12).
8) Loosen the paper belt tensioning lever screw and remove the paper belt from the
lower feeder assy gear and the gear from its axis.
9) Remove the circlip retaining the lower feeder gear to the axis.
10) Unscrew the four screws securing the cut sheet profile to the mechanical assy.
11) Remove the cut sheet profile by simply extracting it from the front.
12) Remove the circlip retaining the lower feeder axis on the right side of the mechanical
assy and shift the feeder assy from its location.
13) Remove the lower feeder assy by simply extracting it from the mechanism.
Replace the lower feeder assy following the above instructions in reverse order.
NOTICE : the lower feeder assy replacement requires an appropriate carriage and paper
belts adjustment procedure (refer to chapter 5).
____________________________________________________________________________________________
LA400 Multiprinter 4. 20 ER-LA400-SV
