Maintenance Manual Removal and Replacement
____________________________________________________________________________________________
4.3.3 Print Head
WARNING
The print head may have hot surface after a certain time of printing.
Wait for it to cool down.
1) Open the top cover group by acting on the two push-buttons (located on the front side
of the cover).
2) Place the print head to the rightmost carriage position and remove the inked ribbon
cartridge and bail assy.
3) Unscrew the screw securing the print head cable to the carriage assy.
4) Unscrew the two screws securing the print head.
5) Open the printhead cable zif-connectors and unplug these connectors and the color
motor connector (if present) by manually acting on their bends.
6) Remove the printhead.
Replace the Print Head following the above instructions in reverse order.
NOTICE : Before securing the screw, push the P.H. to its inside stop position.
No adjustment is required.
Figure 4.3 Printhead Removal
____________________________________________________________________________________________
LA400 Multiprinter 4. 6 ER-LA400-SV
