Maintenance Manual Removal and Replacement
____________________________________________________________________________________________
4.3.9 Ribbon Motor
1) Remove the Main Rear and Front Covers (refer to chapter 4.3.4 and 4.3.5)
2) Remove the circlip retains the pivot assy to the left ribbon cartridge support.
3) Unscrew the four screws securing the left ribbon cartridge support on the left side of
the mechanical assy.
4) Extract the ribbon motor from the plastic support.
5) Remove the plastic support and the pivot assy from the mechanical assy.
6) Unplug the ribbon motor connector from the main board and extract the cable from its
cable retainers located in the rear part of the mechanical assy.
7) Remove the pivot assy.
Replace the ribbon motor assy and the left support parts following above instructions in
reverse order.
Figure 4.9 Ribbon Motor and left cartridge support
____________________________________________________________________________________________
LA400 Multiprinter 4. 12 ER-LA400-SV
